Ernie Ball VP Disassembly?

Amplifiers, effects, pickups, electronic components, wiring, etc.

Moderator: Dave Mudgett

User avatar
Richard Sinkler
Posts: 17790
Joined: 15 Aug 1998 12:01 am
Location: aka: Rusty Strings -- Missoula, Montana

Ernie Ball VP Disassembly?

Post by Richard Sinkler »

I inherited this EB volume pedal. I want to disassemble it to clean it but have a question.

It appears you have to remove the axle, It goes through 2 blocks inside the pedal. Anyone know what the screws are in the block to hold the axle?

The pot seems to be OK. What value would you recommend if using it after a pedal board I have for my resophonic guitars that are amplified using the Gold Tone ABS-d clip-on mic and preamp?

This will not be used on PSG except in an emergency.
Carter D10 8p/7k, Dekley S10 3p/4k C6 setup, Regal RD40 Dobro, Recording King Professional Dobro, NV400, NV112, Ibanez Gio guitar, Epiphone SG Special (open G slide and regular G tuning guitar) .

Playing for 55 years and still counting.
Top
User avatar
Bill A. Moore
Posts: 1429
Joined: 2 Jul 2007 3:17 pm
Location: Silver City, New Mexico, USA

Post by Bill A. Moore »

I just checked one of mine 5/64" Allen.
Top
User avatar
Richard Sinkler
Posts: 17790
Joined: 15 Aug 1998 12:01 am
Location: aka: Rusty Strings -- Missoula, Montana

Post by Richard Sinkler »

Thanks Bill.
Carter D10 8p/7k, Dekley S10 3p/4k C6 setup, Regal RD40 Dobro, Recording King Professional Dobro, NV400, NV112, Ibanez Gio guitar, Epiphone SG Special (open G slide and regular G tuning guitar) .

Playing for 55 years and still counting.
Top

Return to “Electronics”